Should You Pressure Wash a Shingle Roof in Northwest Florida?
Short answer: No. Do not high-pressure wash an asphalt shingle roof. A low-pressure soft wash is the right method for the black streaks on homes in Pace, Milton, East Milton, and Bagdad.
No. Do not high-pressure wash an asphalt shingle roof. A low-pressure soft wash is the right method for the black streaks on homes in Pace, Milton, East Milton, and Bagdad.
Those streaks are common on Santa Rosa County roofs. Gulf Coast humidity, shade from pines and oaks, and summer storms keep the north slope and the roof under the trees damp.
What the Black Streaks Actually Are
The brown-to-black marks are usually algae. The Asphalt Roofing Manufacturers Association says discoloration in that color is easy to mistake for fungus, soot, dirt, moss, or tree droppings, and that Gloeocapsa magma is probably the most common of the algae that cause it. It travels through the air and collects on the roof. Pigment in the organism can turn a light-colored roof dark brown or black, evenly or in streaks. ARMA says this is most widespread in the Gulf States, in warm, humid conditions, and that almost every roof type can pick it up. It shows most clearly on lighter shingles.
GAF technical bulletin TAB-R-102, dated September 19, 2024, calls the same stain blue-green algae, the cyanobacteria Gloeocapsa magma. Spores move from roof to roof on the air. A dark sheath protects the algae from ultraviolet light. Dew is the main moisture. The stain usually covers more of the lower roof and tapers toward the ridge, and it is generally heavier on the northern exposure because that side gets less sun. Pines and oaks in Milton do the same thing to other slopes: the canopy blocks sun, and needles and leaves hold moisture on the shingles after a storm.
Homeowners often hear that the algae feeds on the limestone filler in the shingle. That filler is mostly calcium carbonate. A 2002 Journal of Light Construction report quotes specialists who said alkaline limestone gives algae a favorable environment and may release minerals algae can use. The same report says algae still grows when the filler is not limestone, and that algae do not eat the asphalt. Streaks alone are not proof the roof must be replaced. ARMA's and GAF's cleaning bulletins do not describe a food source. They name the organism and say not to power wash it off.
What High Pressure Does to Shingles
ARMA is direct: do not use a power washer, a brush, or a broom to clean algae off asphalt shingles. High-pressure washing is likely to damage the roofing and should not be used to remove algae or any other stain or dirt. Scrubbing can loosen and remove granules.
GAF says not to power wash shingles, including when a company offers that service. It may dislodge granules, and lost granules can lead to premature shingle failure.
Do not aim a hard stream up under the laps. Forcing water under the shingles is a way to start a leak, which is also why a roof with lifted shingles or an open deck should not be washed. The rinse ARMA describes is a gentle spray across the surface.
How a Soft Wash Works
A soft wash uses diluted sodium hypochlorite at low pressure, dwell time, and a gentle rinse. ARMA describes household bleach and water, applied gently, left on the roof for at least 15 minutes and no more than 20, then rinsed by gently spraying with water. The lightening is only temporary, and the discoloration may come back. Mix strength varies by shingle manufacturer and by how heavy the stain is. Any chemical besides bleach and water needs that manufacturer's approval. Keep the solution off the rest of the house and the landscaping. The wet roof is slippery. ARMA says walking or working on a roof is dangerous and that trained professionals should do it. Do not climb the roof to try this.
GAF publishes a mix of 4 gallons of water, 1 gallon of bleach, and 1 cup of TSP or a phosphate-free substitute, applied with a garden sprayer, left up to 20 minutes, and rinsed with low-pressure water. Protect the shrubs below. A surfactant is often added so the solution stays on the slope for the full dwell instead of running into the gutter. ARMA requires the shingle manufacturer's approval for anything beyond bleach and water, so that additive has to be one the manufacturer allows. The ratios are GAF's published mix, not a project for a homeowner on the roof.
The longer comparison is pressure washing versus soft washing. Low-pressure cleaning for shingles and siding is soft wash.
Read the Warranty You Actually Have
Manufacturers such as GAF, and the Asphalt Roofing Manufacturers Association, advise against power washing asphalt shingles. The warning is about damage, including granules. It is not a claim that pressure washing voids every shingle warranty. Terms differ by brand and by product. Read your own warranty, or ask the manufacturer, before you treat a cleaning method as allowed or forbidden. We will not tell you how a claim will come out.
When the roof is being replaced, ARMA says algae-resistant shingles are made to inhibit growth for an extended period. GAF describes copper that releases over time on certain of its shingles, and algae-protection limited warranties on specific products. That is a reroofing choice, not a reason to power wash the roof you have.
Metal and Tile Roofs
This answer is for asphalt shingles. ARMA notes that almost all roofing systems can discolor from algae, and the bulletin does not give a metal or tile recipe. Do not put the shingle mix on another roof without the maker's approval.
Stone-coated metal shows how the rules change. DECRA's cleaning bulletin says not to use water pressure above 500 psi, to use spray as a rinse rather than as the way you remove growth, and not to use copper- or iron-based products. Copper can corrode those panels, and iron can rust-stain them. That 500 psi cap is DECRA's, not a number for asphalt shingles or for every metal roof. Clay and concrete tile are different again. Do not walk tile or wash it like a driveway until that manufacturer says the method is allowed.
What to Ask a Roof Cleaning Contractor
- Method. The job should be a soft wash. Blasting the streaks off is what ARMA and GAF say not to do.
- Pressure. Ask what pressure will be used to apply the solution and to rinse. You want low pressure and a gentle rinse, not a surface cleaner or a tight stream on the shingles.
- Solution. Ask what is in the tank. It should be diluted sodium hypochlorite. A surfactant, TSP, or any substitute needs the shingle manufacturer's approval.
- Landscaping. Ask how plants under the eaves will be protected. ARMA says to avoid damage to the landscape and the rest of the building. GAF says to protect shrubs below.
- Insurance. Ask for proof of liability insurance before anyone works on the roof. Stay on the ground for the quote. A photo of the streaks from the yard is enough.
The service is roof cleaning in Pace & Milton. Most residential roof cleaning jobs in the Pace and Milton area run $400–$800 depending on roof size, pitch, accessibility, and severity of growth. That is the range on our roof cleaning page, not a price for your house.
Black streaks do not, by themselves, mean the roof has to be replaced. They are discoloration. A soft wash can lighten them, and ARMA says they can return. Cracked, curled, or missing shingles are a roofer's question. We do not repair or replace roofs.
Questions About Pressure Washing a Shingle Roof
Should you pressure wash a shingle roof?
No. Do not use a power washer, brush, or broom on asphalt shingles. The Asphalt Roofing Manufacturers Association says high-pressure washing is likely to damage asphalt roofing. GAF says power washing may dislodge granules. A low-pressure soft wash is the method those bulletins describe.
What are the black streaks on asphalt shingles?
They are usually algae. ARMA says Gloeocapsa magma is probably the most common species, and that the brown-to-black color can be mistaken for dirt, soot, fungus, moss, or tree droppings. Around Pace and Milton, shaded slopes under pines and oaks show it first.
Will soft washing void my shingle warranty?
No single rule covers every brand. GAF and ARMA advise against power washing shingles. They do not say that every soft wash voids every warranty. Read your own shingle warranty, and skip any cleaner the manufacturer has not approved.
Can I wash the streaks without walking on the roof?
Do not walk the roof. ARMA says the work is dangerous, wet shingles are slippery, and trained professionals should do it. A spray from the yard does not treat a whole slope. Send a photo from the ground when you ask for a quote.
Do black streaks mean I should replace the roof?
Not by themselves. The streaks are algae discoloration. ARMA says a bleach cleaning can lighten them and that the color may come back. Cracked, curled, or missing shingles are a repair, not a wash. We do not replace roofs.
Get a Quote
Call or text (850) 845-9110 or Get a Quote. Neighborhoods in Milton are listed on that page. Say whether the roof is shingle, metal, or tile, and send a photo from the ground.